Journal: Bioengineering

Article Title: In-Silico and In-Vitro Analysis of the Novel Hybrid Comprehensive Stage II Operation for Single Ventricle Circulation

doi: 10.3390/bioengineering10020135

Figure Lengend Snippet: Development of a 3D CAD model of the HCSII centerpiece from deidentified angiographic images ( A ). Diameter of RCA, RSA, LCA, and LSA ( B ). Diameter of MPA root ( C ). Dimension of the 3D phantom with the labeled diameters (in mm) of labeled branches using CATIAv.5 ( D ). Diameters of the aortic arch and descending aorta ( E ). Diameter of AA ( F ). Diameter of MPA.

Article Snippet: The following supporting information can be downloaded at: https://www.mdpi.com/article/10.3390/bioengineering10020135/s1 , Table S1: Statistical analysis using One way ANOVA for in-vitro PRT study of patient 1; Table S2: Statistical analysis using One way ANOVA for in-vitro PRT study of patient 2; Figure S1: Development of 3D CAD model of HCSII centerpiece from deidentified angiographic images for performing in-vitro studies.

Techniques: Labeling

Journal: Scientific Reports

Article Title: Thermal insensitivity of an ENZ-ITO clad, hollow-core micro-ring resonator

doi: 10.1038/s41598-024-82147-7

Figure Lengend Snippet: Steps to fabricate the hollow-core resonators. ( a ), The IP-Dip core is printed from a 3D CAD model using the Nanoscribe Photonic Professional GT2. ( b ), A sacrificial Si layer is deposited onto the core. The substrate was mounted onto a rotating stage at an angle steep enough to ensure even coverage around the MRR and to make sure adequate coverage inside the drain channels. The ITO layer was then deposited in a similar way, but at a shallow angle to make sure the sacrificial Si layer was still exposed in the drain. ( c ), The Si layer was removed with a XeF2 etch and then the IP-Dip core was ashed and removed via an annealing step. This final anneal step simultaneously processed the ITO to achieve an ENZ condition.

Article Snippet: Fig. 6 Steps to fabricate the hollow-core resonators. ( a ), The IP-Dip core is printed from a 3D CAD model using the Nanoscribe Photonic Professional GT2. ( b ), A sacrificial Si layer is deposited onto the core.

Techniques: